Before we get started installing and setting up our packages, we will first run an update on the Raspberry Pi by entering the following two commands into the terminal. Remember for this tutorial you will need to have an active Wi-Fi router to connect to and an ethernet device you intend on bridging the Wifi connection to.ġ. We will also need to utilize the hostapd package, this is the package that will allow us to setup one of our Wi-Fi modules as an access point. To setup our Raspberry Pi Wifi Extender we will need to utilize the dnsmasq package, this package handles most of the grunt work for this tutorial as it acts as both our DNS and DHCP server for our connections. Equipment Listīelow are all the bits and pieces that I used for this Raspberry Pi WiFi Extender tutorial, you will need two WiFi dongles to be able to complete this tutorial, at least one must be able to act as an access point. Please note however, this tutorial will require some slight changes, we will explain those changes needed at the end of this tutorial. Basically, it will show how to setup a OpenVPN client and redirect all traffic through that client. This tutorial can be combined well with our VPN Access Point tutorial, you can find the tutorial on how to set that up located directly after this tutorial. The main reason for this is that you must wait for the traffic to go over your initial Wi-Fi connection then be repeated from your Raspberry Pi for devices to connect to. You will face a fair bit of degradation in the speed of your network connection when connecting to the Wifi repeater. The main difference being that instead of getting its network connection from Ethernet, it instead gets its network connection from a WiFi adapter.įor this reason, to complete this tutorial you will require two WiFi adapters, one of these must be access point capable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |